Watermark is shifted when using zoom to fill in Print Module (LR6)

  • 1
  • Problem
  • Updated 3 years ago
This has been noted by someone else for LR5.3, but I wanted to raise it for LR6.

If you select "Zoom to Fill" and the image aspect ratio is significantly different to the print aspect ratio, then you can drag the image around inside the print frame to adjust the print composition. While doing this, the screen image shows the watermark in the correct place (ie it doesn't move as you drag the image around). When printed, however, the watermark is shifted and thus is either cropped at the image edge or inset too far, depending on how far you have dragged the image.

You can work around the problem by cropping to the print aspect ratio before going to the print module, but it's somewhat inconvenient. The real problem is that the preview doesn't alert you to the problem.
Photo of Steve Russell

Steve Russell

  • 2 Posts
  • 0 Reply Likes
  • irritated

Posted 3 years ago

  • 1

Be the first to post a reply!