ACR: Saving raw in jpeg (not enough memory)

  • 1
  • Question
  • Updated 5 years ago
  • (Edited)
Hello I am using Camera raw with following config:
AMD Athlon II x2 245 processor 2.90 GHz RAM:4,00 Go 32 bits
I know that it is not enough especially in Ram but I am not alone in this case. So very often I have to close Camera raw because I have got the message not enough memory to continue jpeg conversion (especially on photo with heavy modification :noise etc). It is also because I am saving in JPEG and using at the same time Camera raw to continue my work, some time to time I have 3 or 4 jpeg conversions at the same time. So I found a solution which gives a little bit better results:
I process all my photos with camera raw without saving in Jpeg . When my work is finished I reload each photos with camera raw and immediately without waiting I save it in Jpeg than I close camera raw and reload a new photo and so on. In that case I have less problèms. My suggestion would be or may be it is already possible : saving the the modified raw photo in jpeg directly from bridge without loading them in camera raw and if possible in batch process. a similar system would be good also for lightroom.Thanks for your comments
Photo of Dan

Dan

  • 1 Post
  • 0 Reply Likes

Posted 5 years ago

  • 1

Be the first to post a reply!